MBM BC-12, Руководство по эксплуатации

Страница: 25 / 38

23
5.8 Starting operation
∗
Press the Start Key to start operation.
∗
The Start LED lamp (green) is lit while the machine is in operation, and the Stop LED lamp (red) is lit
when operation has stopped.
∗
So far, this manual has explained various setting methods, including how to release errors, select the
cutting mark function, select the counter mode function, and adjust the top margin. However, if these
settings or adjustment are not necessary, basic operations can be performed as follows.
[1] Load the paper in the paper feed tray.
↓
[2] Select the cutting mode.
↓
[3] Specify the number of products to be cut (only when the preset mode is set).
↓
[4] Press the Start Key to start operation.
5.9 Stopping operation
∗
If the Stop Key is pressed while the machine is in operation, the Stop LED lamp (red) lights, and after
the cutting process in progress has finished, the machine stops operation.
∗
If the Start Key is pressed after the operation is stopped, the machine starts operation again.
(Do not press the Start Key or Stop Key before the operation stops.)
5.10 Emergency stop and safety device (Interlock)
∗ If [1] the top panel or slitter cover is opened, or [2] the trash box is pulled out, during operation, the
machine stops immediately. If an emergency stop is necessary, use either of these methods.
∗
To start operation again after [1] closing the top panel or slitter cover, or [2] installing the trash box,
and after removing any sheet or scrap of paper remaining in the machine, press the Ready/Clear Key
to put the machine in the stand-by state.
∗
While the top panel or the slitter cover is open or the trash box is not set to its proper position the
machine power can not be turned on and the display goes out because of safty feature.
Because this function is part of the machine’s safety feature, the machine does not work until the top
panel, slitter cover and trash box are returned to their proper positions.