2. To calibrate, press and hold the
RESET control for
approximately ten seconds until
CAL appears. Release the
control.
3. Slowly drive the vehicle in a circle (less than 3 mph [5 km/h]) until
the CAL display changes to the direction value. It may take up to
five circles to complete calibration.
4. The compass is now calibrated.
AUXILIARY POWER POINT (12V)
Power outlets are designed for accessory plugs only. Do not insert
any other object in the power outlet as this will damage the
outlet and blow the fuse. Do not hang any type of accessory or
accessory bracket from the plug. Improper use of the power
outlet can cause damage not covered by your warranty.
The auxiliary power point is located
in the instrument panel.
A second auxiliary power point is
located on the rear side of the
center console.
Do not use the power point for
operating the cigarette lighter
element (if equipped).
To prevent the fuse from being
blown, do not use the power
point(s) over the vehicle capacity of 12 VDC/180W. If the power point or
cigar lighter socket is not working, a fuse may have blown. Refer to
Fuses and relays
in the
Roadside Emergencies
chapter for information
on checking and replacing fuses.
To have full capacity usage of your power point, the engine is required to
be running to avoid unintentional discharge of the battery. To prevent
the battery from being discharged:
•
do not use the power point longer than necessary when the engine is
not running,
2009 Tribute Hybrid
(thv)
Owners Guide, 1st Printing
USA
(fus)
Driver Controls
66
