Mazda 2006-2008 RX7 Engine, Руководство по ремонту

Страница: 56 / 60

MECHANICAL
01–10–42
2. Install the M6
×
1.0 bolt in by hand.
3. Turn the crankshaft clockwise so that the
crankshaft is in the No.1 cylinder TDC position.
4. Hold the crankshaft pulley using the SST .
5. Tighten the crankshaft pulley lock bolt in the order
shown following two steps using the SST (49
D032 316) .
Tightening torque
(1) 96—104 N·m
{9.8—10.6 kgf·m, 70.9—76.7 ft·lbf}
(2) 87
°
—93
°
6. Remove the M6
×
1.0 bolt.
7. Remove the SST from the camshaft.
8. Remove the SST from the block lower blind plug.
9. Rotate the crankshaft clockwise two turns until
the TDC position.
•
If not aligned, loosen the crankshaft pulley lock bolt and repeat from Step 1.
10. Install the cylinder block lower blind plug.
Tightening torque
18—22 N·m {1.9—2.2 kgf·m, 13.3—16.2 ft·lbf}
Cylinder Head Cover Assembly Note
1. Apply silicone sealant to the mating faces as
shown in the figure.
Caution
•
Install the cylinder head cover within 10
min of applying the silicone sealant.
Dot diameter
4.0—6.0 mm {0.16—0.23 in}
2. Install the cylinder head cover with a new gasket.
3. Tighten the bolts in the order shown in the figure.
Tightening torque
8.0 —10.5 N·m
{81.6—107.1 kgf·cm, 70.9—92.9 in·lbf}
End Of Sie
BOLT
B3E0110E063
49 E011 1A0
E5U110ZE7S11
SEALANT
SEALANT
B3E0110E064
9
8
7
5 4
3
1
2 10
14
13
11
12 6
B3E0110W050