Adjust Your Crossbars
•
If you have a TRIBUTE, move crossbars to 26” apart.
•
For other vehicles with bars that can be moved, move the bars to 30” apart.
TIGHTEN YOUR CROSSBARS IF YOU LOOSENED THEM.
1
Part # 1032597 Rev A
Position the Support Brackets ABOVE Your Vehicle’s Crossbars
•
Place the brackets second slat from each end (except Tribute front,
see illustration) and INSIDE of the basket frame
•
Tabs on brackets must face OUTBOARD
•
Keep crossbar centered below tab!
It may be necessary to move the bracket to a
new position, or to adjust the basket position.
5
Page 2 of 3
Tribute Only:
26”
30”
Tribute Only:
Assemble the Basket
•
Remove the machine screws and washers
from the ends of the LoadWarrior tubes.
•
Attach the two basket halves by pushing
the tube ends together.
•
Insert screws and washers into tube joints and tighten.
2
Attach Fairing to Either End of Basket
•
Pry open the SnapArounds, attach them
to the LOWER FRONT BAR
•
Insert bolts through washers, fairing and SnapArounds.
•
Attach knobs and TIGHTEN
•
NOTE: Fairing can fold down when
carrying long slender loads.
3
Load Basket onto Racks
•
Center basket over your rack’s crossbars.
•
Do not attach to less stable center
locations (see diagram)
4
A friend
would make
this easier .
(SIDE VIEW)
Do not attach brackets at these locations.
FRONT
In some situations the crossbar may sit off
center of the bail.
