Page 2 of 8
AS 090-M11411cma0709
A. With hood open, lay front end cover over front of vehicle. On both sides of vehicle slip pocket (E) over edge of upper bumper
bracket above headlight.
B. Attach clips (F) to upper edge of bumper facia on both sides of hood latch.
4
Install upper attacments
E
F
E
E
F
3
Install wheel well hardware
A. In both front wheel wells, lift wheel well liner to reveal holes.
B. Slip u-nuts (B) over holes in metal edge that correspond to
the front mask. Make sure that the holes are aligned
properly.
C. Release liner to its original position. Using a stubby phillips
screwdriver, install washer (C) and snap head screws (D)
into holes with newly installed u-nuts.
2
Remove wheel well fasteners
A. Using stubby phillips screwdriver, remove the four plastic
fasteners illustrated below along front edge of both front
wheel wells.
B
B
D
C
C
D
