AS 090-M11356cmc1105RevA
Page 1 of 4
Genuine Accessories
Installation Instructions
Part Number
0000-8G-K01
Applicable Models:
2004 Mazda RX8 Base
Package Contents
Front Mask
U-Nut (Qty. 8)
Tools Required
Stubby Phillips
Screwdriver
Hood Cover (Qty. 1)
Snap Head Screw (Qty. 8)
Front End Cover (Qty. 1)
0
Before Installation
A. Area to be covered by mask must be clean. It is recommended that you wash and wax vehicle prior to installation.
B. Both vehicle and mask must be completely dry prior to installation. If moisture under mask is allowed to dry on
vehicle, paint may cloud.
C. Any repainted surfaces in contact with mask must be allowed to cure completely. Consult paint manufacturer or
repair facility if you are not sure.
1
Install Hood Cover
A. With hood open, stretch hood cover (A)
onto hood, pulling each side one or two
inches at a time, until corners fit snugly.
Install hooks on ends of straps (B) into
corresponding holes in hood. Pull
evenly on ends of adjustable straps (B)
until tight. Secure loose ends in elastic
loops.
Washer (Qty. 8)
2
1
3
A
B
B
