3. Route EC harness down driver-side A-pillar.
a) Route power harness along factory harness in
driver-side A-pillar.
(Fig. 3-3)
b) Secure power harness to factory harness with
three (3) tie wraps.
(Fig. 3-3)
c) Cut excess material off tie wraps.
4. Route power harness to driver-side kick-plate area.
a) Route power harness through driver-side
instrument panel and into kick-plate area.
(Fig. 3-4)
1. Attach wire tap connectors to B+ and +12V ignition.
a) Locate the wire bundle in the driver-side kick
plate area.
(Fig. 4-1)
b) Remove electrical tape wrapping as required
to access wires.
c) Locate
Orange / Black-stripe wire (B+)
in the
kick plate wire bundle.
d) Using pliers, secure wire tap to
Orange / Black-stripe wire
.
(Fig. 4-2)
e) Locate the
Orange / Yellow-stripe wire (+12V)
in the bundle.
f) Using pliers, secure wire tap to
the
Orange / Yellow-stripe wire. (Fig. 4-2)
Fig. 4-2
Fig. 3-4
Fig. 3-3
CAUTION
!
Tie
Wraps
CAU
TION
!
Verify mirror harness path is clear of air bag (if equipped).
CAUTION
!
Do not tie wrap harness to sunroof drain tube (if equipped).
4
Connect Harness Power and Ground
Fig. 4-1
Remove
Tape
Orange /
Black-stripe
Wire
Orange /
Yellow-stripe
Wire
Page 5 of 8
Revision A
550-0336
