Attach the floating cable to the power supply.
Robot operation
Maintenance
Set Up
Into the pool
Operation
Out of the pool
Storage
Periodic filter cleaning
Cleaning the impeller
Cleaning the filter
away from the edge of the pool.
Position the power supply at least 3m/10ft
Turn the power supply ON.
The Pool Cleaner will now
operate until it has reached
the end of the cleaning cycle.
It is highly reccomended to clean the filter basket after each cleaning cycle.
Note: Don’t let the filter cartridges dry out before cleaning.
Unplug the power supply before servicing
Clean the debris trapped in the impeller opening,
according to the following steps:
Lift up the basket.
Open the latch to
release the bottom
lid in order to remove
the debris.
Clean the filter basket
with a hose.
Open the filter cover.
If you notice debris trapped in the impeller:
Coil the cable and store in a cool, dry place on the Caddy.
Do NOT store the robot where it will be exposed to direct sunlight, excessive heat or to frost.
Unplug the power supply before servicing
Put the Pool
Cleaner into the
pool.
Release the Pool
Cleaner and let it
sink to the floor
of the pool.
Make sure that the
floating cable is
free of any
obstructions.
6
Dismantle the 4 ultra-fine filter panels of the outer basket according to the following steps:
Holding down the handle
remove the inner net basket.
Dismantle the panels,
starting with pressing on
panel no.1 using your
thumbs.
Continue to dismantle the panels in the
order of their nombers: no.2--> no.3-->
no. 4.
1
2
1
2
4
5
1
2
3
1
2
ON
6a
2
1
3
1
3
2
3
5
2
7
1
4
6b
6c
6d
Cable Tip:
Unwind the
cable &
stretch it out
poolside so
that it has
no kinks