11
Changing the Sensor Cycle settings
to increase drying time
If all your loads on all Sensor Cycles are consistently less dry
or more dry than you would like, you may change the default
settings to increase or decrease the default dryness level.
Your sensor drying settings can be adjusted to adapt to
different installations, environmental conditions, or personal
preference. This change is retained and will affect all of your
Sensor cycles, not just the current cycle/load. There are 5
drying settings, which are displayed using the time display:
0
Much wetter clothes, 30% less drying time.
1
Slightly wetter clothes, 15% less drying time.
2
Factory preset dryness level.
3
Slightly drier clothes, 15% more drying time.
4
Much drier clothes, 30% more drying time.
To change the drying settings:
NOTE:
The settings cannot be changed while the dryer is
running or paused. The dryer must be in standby mode (power
is off) to adjust the default settings.
1.
Without turning on the dryer, touch and hold DRY LEVEL
for 6 seconds.
2.
Touch DRY LEVEL to select the dryness level shown in the
time display: 0, 1, 2, 3, or 4.
3.
Touch START to save the new dryness level setting.
NOTE:
If any other keypad is touched, or after 20 seconds, the
dryer will return to Standby without saving any changes.
ADDITIONAL FEATURES
USING THE DRYING RACK
To obtain a drying rack for your dryer, order by calling
1-800-901-2042
. You will need your model and serial
number and the purchase date. Remove and discard any
packing material before use.
Use the Drying Rack for items that you do not want to tumble
dry, such as sweaters and tennis shoes. When you use the
drying rack, the drum continues to turn, but the rack remains
stationary.
The drying rack is intended for use with the Timed Dry cycles
only. The drying rack cannot be used with Automatic cycles.
To use the drying rack:
IMPORTANT:
Do not remove the lint screen.
1.
Open dryer door.
USING THE DRYING RACK (cont.)
2.
Align the two hooks on the front of the drying rack with the
holes in the dryer door opening and press down fully into
holes. Rest the rear support on the dryer back ledge.
3.
Place wet items on top of the drying rack. Allow space
around items for air to circulate. The drying rack does not
move, but the drum will rotate; be sure to leave adequate
clearance between items and the inside of the dryer drum.
Make sure items do not hang over the edges or between
drying rack grille.
4.
Close the door.
5.
Select a Timed Dry/Air Only, or Low Temperature cycle.
Items containing foam, rubber, or plastic must be dried on a
clothesline or by using the Air Only setting.
6.
When the cycle is selected, the Estimated Time Remaining
display shows the default time. You can change the actual
time in the cycle by increasing or decreasing the cycle time.
7.
Start the dryer.
NOTE:
Check the lint screen and remove any lint accumulated
from items dried on the drying rack after the cycle is finished.
Содержание YMEDB955FC0
Страница 3: ...3 ...
