26
INSTALLATION
Check the appliance is electrically safe and gas sound when you have fi nished.
actual opening of the doors is slightly less but this allows
for some protection of your hand as you open the door.
Unpacking the Cooker
Do not take any packaging off the cooker until it is directly
in front of the place it is to be installed (unless it will not fi t
through a door in its outer packaging).
Cut the banding straps and lift the cardboard box off
the cooker, leaving the cooker standing on the base
packaging. See the loose unpacking sheet.
Moving the Cooker
The cooker is very heavy. Take great care.
We recommend two people manoeuvre the cooker.
Ensure that the fl oor covering is fi rmly fi xed, or removed
to prevent it being disturbed when moving the cooker
around. You will need the levelling tool.
From the back tilt the cooker forward and remove the rear
half of the polystyrene base pack.
Repeat from the front and remove the front half of the
poly base. Pull the drawer out to its furthest point.
Find the hexagon headed adjusters at each front corner
of the cooker.
Use the levelling tool to turn the 2 adjusting nuts, one at
each of the front bottom corners of the cooker.
Turn both 10 complete turns clockwise to lower rear
rollers.
Open the grill door and Warmer compartment door. With
your hands under the bottom edge of the hot plate facia,
lift the front of the cooker slightly and then roll the cooker
on the rollers.
Do not use the door handles or control knobs to move the
cooker.
Take care not to twist it within the gap between the
kitchen units as damage may occur to the cooker or the
units.
Levelling
Place the cooker in its intended position taking care not
to twist it within the gap between the kitchen units as
damage may occur to the cooker or the units.
The rear rollers and front feet can be adjusted to level the
cooker. To adjust the height of the rear of the cooker use
the levelling tool supplied to turn the adjusting nuts at the
front bottom corners of the cooker.
To adjust the height of the front of the cooker screw down
the front feet.
Fitting a stability bracket
A stability bracket or chain (not supplied by with the
cooker) should be fi tted when the cooker is connected to
a fl exible gas supply.
When fi tting a stability bracket read these instructions
together with the leafl et supplied with the bracket.
