7
S
PECIAL LAUNDRY TIPS
CONT.
Lint filter
Maytag's self cleaning lint filter works
throughout the wash cycle to constantly
remove lint and other residue from the
water. Located between the outer and
inner tub, the lint filter removes lint as
water passes from the bottom of the outer
tub back to the inner tub. As water passes
from the outer tub to the inner tub, water
is forced through the bottom of the lint fil-
ter. The filter traps lint under the filter until
the spin cycle begins. During the spin
cycle centrifugal force removes the lint by
pulling it off the bottom of the filter and
washing it down the drain.
Motor overload
protector
Internal overload protector automatically
stops motor in event of overload.
Overload protector resets in approximate-
ly 3 minutes and motor automatically
restarts. If overload protector stops motor
again, stop using washer and call service
technician. Loading wash tub too full may
result in motor overload.
Automatic balance system
Your new washer will automatically adjust
to unbalanced loads without shutting
down or interrupting the cycle. The cycle
will automatically complete at the fastest
spin speed possible.
In a severe out-of-balance condition,
clothes may contain excessive moisture. If
this should happen, simply redistribute the
clothes, and reset the control to the spin
mark after the rinse setting in the regular
cycle.
Safety lid switch
The washer will not spin when the lid is
open for any reason. This is for your per-
sonal safety. If the lid is opened mid-cycle,
operation will automatically start when lid
is closed.
General washer care
• Use only damp or sudsy cloth for
cleaning control panel. Some cleaning
product sprays may harm control panel
finish or may damage interior of hood.
• Wipe washer cabinet as needed. If
detergent, bleach, or other washing
products are spilled on cabinet, wipe
immediately. Some products will cause
permanent damage if spilled on cabi-
net.
• Top of washer should not be used for
removing garment stains. Some stain
removers, such as rust remover, may
damage cabinet finish.
• Do not use scouring pads or abrasive
cleansers.
• Do not lay sharp or rough objects on or
against washer. Finish could be dam-
aged.
• Remove pins, buckles, or other sharp
objects from clothes to prevent
scratching interior parts.
• Leave lid open after use to allow inside
of washer to dry, and to help prevent
musty odors from developing.
• Do not allow small children to play on
or around washer.
• Do not move washer without rein-
stalling shipping brace and shipping
plug. See Moving Washer to New
Location section.