5
■
Cooktop light: The cooktop light is located on the underside of the
microwave oven, and is replaceable. Remove bulb cover screw,
and open the bulb cover. Replace bulb, close bulb cover, and
secure with screw.
■
Cavity light: The cavity light bulb is located behind the vent grille
at the top front of the microwave oven, under the bulb cover, and
is replaceable. Open door. Remove two screws on the vent grille,
tilt the grille forward, and lift it out. Remove right side charcoal
filter. Open bulb cover and replace bulb. Close bulb cover, replace
charcoal filter, replace vent grille, and secure with screws.
Following is a list of available parts and supplies which may be purchased separately. Please refer to the cover for contact and model
identification information.
Replacement Parts
■
Turntable
■
Turntable support and rollers
■
Turntable hub
■
Cooking rack
■
Rack clip
■
Rack support
■
Grease filter
■
Charcoal filter
■
Cooktop light bulb
■
Cavity light bulb
Cleaning Supplies
■
Heavy Duty Degreaser
■
affresh
®
Kitchen Appliance Cleaner
■
affresh
®
Stainless Steel Cleaner
■
affresh
®
Stainless Steel Wipes
ACCESSORIES
Scan the code at left with your mobile device, or visit
https://www.maytag.com/product_help for more recommendations that may help
you avoid a service call.
If you experience Recommended Solutions
Microwave oven will
not operate
Check the following:
■
Household fuse or circuit breaker - If a household fuse has blown or a circuit breaker has tripped, replace the
fuse or reset the circuit breaker. If the problem continues, call an electrician.
■
Magnetron - Try to heat 1 cup (250 mL) of cold water for 2 minutes at 100% cooking power. If water does not
heat, try the steps in the bullets below. If microwave oven still does not operate, call for service.
■
Door - Firmly close door. On some models, if a packaging spacer is attached to inside of the door, remove it,
then firmly close door.
If a message about the door appears in the display, the door has been closed for 5 minutes or more without the
microwave oven being started. This occurs to avoid unintended starting of the microwave oven. Open and close
the door, then start the cycle.
■
Control - Make sure control is set properly. Make sure Control Lock is off. Make sure Demo Mode (on some
models) is off.
Arcing in the
microwave oven
Check the following:
■
Soil buildup - Soil buildup on cavity walls, microwave inlet cover, cooking rack supports, and area where the
door touches the frame can cause arcing. See “General Cleaning” in “Microwave Oven Care” section.
Turntable alternates
rotation directions
■
This is normal and depends on motor rotation at the beginning of the cycle.
Display shows
messages
■
“Enter clock” with flashing digits means there has been a power failure. Reset the clock.
■
A letter followed by a number is an error indicator. Call for assistance.
Fan running during
cooktop usage
■
This is normal. The microwave oven’s cooling fan, which is separate from the vent fan, automatically comes on
during microwave oven operation to cool the microwave oven. It may also automatically come on and cycle on
and off to cool the microwave oven’s controls while the cooktop below is being used.
Radio, TV or cordless
phone interference
Check the following:
■
Proximity - Move the receiver away from the microwave oven, or adjust the radio or TV antenna.
■
Soil - Make sure the microwave oven door and sealing surfaces are clean.
■
Frequency - Some 2.4 GHz-based cordless phones and home wireless networks may experience static or noise
while microwave oven is on. Use a corded phone, a different frequency cordless phone or avoid using these
items during microwave oven operation.
PROBLEM SOLVER
