Maytag MHW9000 Series, Инструкция по использованию и уходу

Страница: 18 / 40

18
First try the solutions suggested here or visit our website at www.maytag.com/help
for assistance and to possibly avoid a service call.
If you experience
Possible Causes Solution
Door not closed completely.
Make sure the washer door is closed completely.
Press and hold the START/PAUSE button 2-5 seconds.
Household fuse is blown or circuit
breaker has tripped.
Check that the household fuse is intact and tight, or that the
circuit breaker has not tripped. Replace the fuse or reset
the circuit breaker. If the problem continues, call a qualified
electrician.
TROUBLESHOOTING
Washer will not run
START/PAUSE button not pressed
firmly or held long enough.
Washer Operation
Incorrect power supply. This washer requires a 120-volt power supply.
Check with a qualified electrician.
Wrong type of household fuse.
Use a time-delay fuse.
Fill hoses not attached tightly. Tighten fill-hose connections.
Make sure all 4 fill hose washers are installed correctly.
Drain hose connection not correct.
Properly secure drain hose to drainpipe or laundry tub. Refer to
the Installation Instructions for additional information.
Check household plumbing for leaks
or clogged sink or drain.
Water can backup out of a clogged sink or drainpipe. Check all
household plumbing for leaks (laundry tubs, drain pipe, water
pipes, and faucets.)
Fill hose washers missing.
Water Leaks
Water leaks
Do not place tape over drain opening.
Other performance
or operation issues
Refer to the built-in troubleshooting
feature on the washer.
See the instructions above to access the built-in
TROUBLESHOOTING menus using the LEARN MORE button.
Other Issues
Clean the door seal. See “Washer Maintenance.” Door seal is dirty.
Use only HE High Efficiency detergents and follow
the manufacturer’s recommendations.
Not using HE detergent or using too
much HE detergent.
Remove and clean the dispenser. See “Washer Maintenance.”
Dispenser is clogged.
1.
Press LEARN MORE
With the washer on, press LEARN MORE to access the built-in
troubleshooting feature. Use the LCD control buttons to select
TROUBLESHOOTING.
USING THE BUILT-IN TROUBLESHOOTING FEATURE
2.
Select TROUBLESHOOTING
Then use the LCD control buttons to select the desired
troubleshooting topic. Use the
and buttons to advance
through the different options.