25
Option B: No Waste disposer—no air gap
Waste tee
Large drain
hose clamp
Drain hose
Drain trap
1
Rubber
end
1.
Fit rubber end of drain hose
to waste tee.
2
2.
Attach rubber end of drain hose to
waste tee with a large drain hose clamp
(provided). Use pliers to squeeze clamp
open and move into position. If the drain
hose was cut, use a 1½" to 2"
(3.8 cm to 5.0 cm) screw-type clamp
(not provided).
Helpful Tip:
Remove disposer knockout plug.
1.
Using a hammer and screwdriver, knock
plug into disposer.
2.
Use needle-nose pliers to remove plug.
3.
Connect rubber end of drain hose
to air gap.
NOTE
: Do not cut ribbed section.
Option C: Waste disposer – with air gap
Large drain
hose clamp
Drain hose
Screw-type clamps
Air gap
Rubber hose
connector
Drain trap
Disposer inlet
1
2
Rubber
end
3
4
4.
Attach drain hose to air gap with large
drain hose clamp (provided). Use pliers
to squeeze clamp open and move into
position. If the drain hose was cut, use a
1½" to 2" (3.8 cm to 5.0 cm) screw-type
clamp (not provided).
5
5.
Use a rubber hose (not provided) with
screw-type clamps to connect from air
gap to disposer inlet.
1.
Connect rubber end of drain hose
to air gap.
NOTE:
Do not cut ribbed section.
2.
Attach drain hose to air gap with large
drain hose clamp (provided). Use pliers
to squeeze clamp open and move into
position. If the drain hose was cut, use a
1½" to 2" (3.8 cm to 5.0 cm) screw-type
clamp (not provided)..
3.
Use a rubber hose (not provided) with
screw-type clamps (not provided) to
connect from waste tee to air gap.
Option D: No waste disposer –
with air gap
Large drain
hose clamp
Drain hose
Screw-type clamps
Air gap
Rubber hose
connector
Drain trap
Waste tee
1
Rubber
end
2
3
