Maytag HK521B, Руководство по установке

Страница: 4 / 8

4
Installing Refrigerator Handle, Trim, and
Door
1. Remove handle plugs from sides of door.
• If handle was installed on refrigerator, plugs will
only be on the non-handle side of the door.
2. Install clips on both sides of door.
• If installing the handle only, proceed to step 11.
8. Install door extension on top of refrigerator door
using 1/4" (6.3 mm) hex head screws.
9. Install top trim on refrigerator door using T-15 Torx
®*
screws.
3. Install bottom trim on refrigerator door using T-15
Torx
®*
screws.
4. Install hinge side trim on door by aligning notches of
trim with clips on side of door.
• Tab end must be towards front of refrigerator.
• Slide trim down until trim locks into place.
• Tap top of trim with rubber mallet to insure snug
fit.
5. Replace door on center hinge.
6. Replace top hinge by replacing 5/16" (7.9 mm) hex
head screws.
• Top hinge and cover for left swinging door is
provided with HTK531 and needs to be installed
on left side of cabinet.
7. Replace top hinge cover by replacing Phillips screw.
10. Install refrigerator panel by sliding panel in from
handle side of door.
11. Install new door handle by aligning notches of
handle with clips on side of door.
•
Slide handle down until handle locks into place.
•
Tap top of handle with rubber mallet to insure snug
fit.
Removing Pullout Drawer
1. Pull drawer open to full extension. Remove Phillips
screw from each side of rail system.
2. Remove lower basket by lifting basket from rail
system.