Maytag AMC4080AAB/W/Q/S, Руководство по обслуживанию

Страница: 19 / 53

Disassembly Procedures
To avoid the risk of electrical shock, personal injury or
death; disconnect power to oven and discharge
capacitors before following any disassembly procedure.
©2004 Maytag Services
16022923 Rev. 0 19
W AR NIN G
!
High voltage is present at the high voltage terminal of the
high voltage transformer during any cooking cycle.
It is neither necessary or advisable to attempt
measurement of the high voltage.
Before touching any oven components or wiring, always
unplug the oven from its power source and discharge
capacitor.
Door Assembly
CAUTION
!
A microwave leakage test must be performed anytime
a door assembly is removed, replaced, disassembled,
or adjusted for any reason.
Door Removal
1. Disconnect power to oven and remove outer case,
see "Outer Case" procedure.
2. Open the oven door to gain access to the upper
hinges. Remove 2 screws securing the upper
hinges.
3. Guide the upper hinge out of the hinge cavity.
4. Gently maneuver the door hinge pin away from the
lower hinge assembly. Lower hinge bracket should
remain attached to the microwave.
NOTE: When aligning the door for assembly, fully open
the door.
5. To place the door back on the unit, gently maneuver
the lower hinge pin onto the lower hinge assembly
while guiding the upper hinge assembly into the
upper hinge assembly cavity. Use caution and do not
allow the upper hinge assembly to separate from the
upper hinge pin. Reattach the two upper hinge
assembly retaining screws.
Upper Hinge
and screws
Lower Hinge
Door Disassembly
1. Disconnect power to oven and remove oven door,
see "Door Removal" procedure.
2. To remove the choke cover, locate one of the plastic
seatings securing the choke cover to the inner door
assembly. Insert a tool near the seating and gently
pry outward. Continue to work around the door
casing (prying near the plastic seatings) until choke
cover is completely loose. Remove the choke cover.
CAUTION
!
To avoid property damage, care must be taken when
prying choke cover from inner door assembly and
when prying inner door assembly from door frame.
3. Once the choke cover is removed, remove the inner
door assembly.
4. To remove the inner door assembly, carefully pry on
the seatings securing the inner door assembly to the
door frame. Continue to work around the door casing
(prying near the plastic seatings) until the inner door
assembly is completely loose. Remove the inner
door assembly.
5. Once the inner door assembly is removed, the door
latch and spring assembly may be removed.
6. When removing door latch and spring assembly,
remove the spring first, then slide latch assembly up
and remove.
7. Reassemble in reverse order.