©2005 Maytag Services
16023515
A – 9
BACKGUARD INSTALLATION
(if not installed)
The backguard fits on the range as shown in figure 1 and
is secured with a bracket, 2 bolts and nuts on each side.
Set the backguard on the rear of the range. Bolt the
backguard to the end panel flanges.
FIGURE 1
DISCONNECT ELECTRICAL POWER TO
AVOID SHOCK HAZARD.
CLEARANCE DIMENSIONS
All free-standing ranges can be installed with the back
against (0 inches) a vertical combustible wall, and the
sides below the cooking surface against (0 inches)
combustible base cabinets. For complete information in
regard to the installation of wall cabinets above the range
and clearances to combustible surfaces see the
installation drawings and/or the model number plate on
the range. For
SAFETY CONSIDERATIONS
do not install
a range in any combustible cabinetry which is not in
accord with the installation drawings and the clearance
given on the range Model Number Plate.
LOCATING THE RANGE
Do not set range over holes in the floor or other locations
where it may be subject to strong drafts. Any opening in
the wall behind the range and in the floor under the range
should be sealed. Make sure the flow of
cooling/ventilation air is not obstructed below the range.
NOTE:
A range should
NOT
be installed directly over
kitchen carpeting.
CONNECTING THE
RANGE
Electric Supply
The appliance, when installed, must be electrically
grounded in accordance with local codes or, in the
absence of local codes, with the National Electrical Code,
ANSI/NFPA 70.
In Canada the range must be installed in accordance with
the current CSA Standard C22.1 - Canadian Electrical
Code Part 1.
ELECTRICAL SUPPLY
CONNECTION:
The range requires 120 volts, 60 cycle alternating current
from an outlet capable of supplying 15 amperes.
User may experience occasional circuit tripping if Ground
Fault Circuit Interrupter (GFCI) outlet or breaker is in use.
Electrical Grounding Instructions
This appliance is
equipped with a (three-prong)
grounding plug for your protection against shock hazard
and should be plugged directly into a properly grounded
receptacle. Do not cut or remove the grounding prong
from this plug.
DISCONNECT ELECTRICAL SUPPLY
BEFORE SERVICING THE APPLIANCE.
Installation Instructions
(Models CG11000AD*, CPL1110AD*,
YPL1110AD*)
