Service Specifications
December 2005
16026830
© 2005 Maytag Services
3
!
WARNING
To avoid risk of electrical shock that can cause death or severe personal injury, disconnect unit from power before
servicing unless tests require power. Discharge capacitors through a 10,000-ohm resistor before handling. Wires
removed during disassembly must be replaced on correct terminals to ensure proper grounding and polarization.
Programming Mode:
NOTE:
The Program Code is located on the Serial Plate on this unit after the word Code.
1. Press and hold the Door Alarm Keypad
Door
Alarm
.
2. Press and hold Freezer Temperature Down Keypad
.
3. Release the Door Alarm Keypad
Door
Alarm
and wait 3 seconds.
4. The control will display PE to indicate the programming mode.
PE
5. Entry is confirmed by pressing the Freezer Temperature Down Keypad
once more.
6. The control will display the current Program CODE. This value should be validated with the Program CODE
printed on the unit serial plate.
PE0
000
NOTE:
If the Program CODE is correct, the Programming Mode is exited by pressing Door Alarm Keypad for 3
seconds.
7. Press the Refrigerator Temperature UP Keypad
or Refrigerator Down Keypad
to change the digit
value with each key press.
8. The decimal point indicates the selected digit. Press the Freezer Temperature UP Keypad
to select the
next digit.
9. Once the desired Program CODE is entered, press and hold the Freezer Temperature DOWN Keypad
until the Program CODE begins flashing indicating it has been saved.
NOTE:
If you attempt to enter an invalid Program CODE the control will not save the new code, but will beep. (The
unit will NOT run with a Program CODE of 0000).Once the Program CODE has been saved the
Programming Mode is exited by pressing any key. If the new code is incorrect this process should be
repeated.
The Programming mode can be exited at any time by pressing Door Alarm key for 3 seconds or will exit if
unattended for four minutes.
