(4)
12. Place the Work Surface (1) face down onto a clean surface.
Position the Upper Hinge (E6) with the hinge tab toward the
bottom edge. Secure with six #10 X 3/4 Screws (E1).
13. With the Pencil Stop (5) removed, insert the Rivet (E9) into
the center hole in the groove. Position it with the Rivet head in
the groove and place the Push Nut (E10) on the end of the Rivet
that protrudes beyond the bottom surface.
1
E9
14. To mount the Work Surface to the base, insert the tabs
of the Upper Hinges into the slots of the Lower Hinges
mounted on the Frame Assembly. Raise the Lift Hinges
until the mounting plate holes are aligned with the pre-drilled
holes in the Work Surface and secure in place with four #10
X 3/4 Screws (E1).
15. Apply Rubber Bumpers (E8) near the end of the Frame
Assembly, farthest from the Hinges.
16. Place the Pencil Stop (5) into the
Work Surface groove.
