MAYBACH COMAND AND REAR-CABIN AUDIOVISUAL SYSTEM, Руководство оператора

Страница: 225 / 319

225
System Settings - Rear Cabin
System settings
Select item
Time
using the selection
wheel on the remote control and
press the selection wheel to confirm.
The time/date setting display ap-
pears.
The following options are now available:
Setting the time ( page 225)
Setting the date ( page 226)
Setting the date/time format
(
page 226).
Setting the time
The UTC time transmitted by the GPS sat-
ellites has to be set to the local time
zone. This enhances
correct navigation for routes with
time-dependent traffic guidance,
and
correct calculation of the estimated
time of arrival.
Press

or

on the remote control
to select hours or minutes.
Press key

or

on the remote
control.
Depending on the selection, hours or
minutes can be set.
Setting the minutes:
With GPS reception, each time

or

on the remote control is pressed,
the minutes change in increments of
30 minutes. Without GPS reception,
the minutes change in 1 minute incre-
ments.
Setting the hours:
Each time

or

on the remote
control is pressed, the hours change
in increments of 1 hour.
Select item
Back
using the selection
wheel on the remote control and
press the selection wheel to confirm.
The new setting is stored.
Setting the date/time
i
There is no automatic change from
daylight saving time to standard
time.
This has to be changed manually.
When you change the time zone, the
clock time also changes automatical-
ly. If you enter an incorrect time, the
time difference remains unchanged
when you change time zone.