Stand 36-1824
English
page 4 of 7
Using a 16 mm hammer drill, drill a min.110 mm-deep hole into the concrete.
Clean the bore hole with compressed air.
Drive the anchor bolt into the hole. Before doing so, be sure to position the hex
nut correctly. (The drive-in pin of the threaded bolt should jut out of the hex nut
approx. 2 - 3 mm.)
Use a torque wrench to tighten the nut with 110 nm.
A falling sunshade can cause serious or even fatal injury.
If the dimensions of the anchor bolts do not match the size of the
umbrella, the sunshade may fall and cause injuries.
Always determine the appropriate bolt size with the help of a specialist.
Anchor bolts of May company are approved for cracked and non-
cracked concrete C20/25 to C50/60. Also suitable for concrete C12/15
and natural stone with dense structure.
4.
When choosing the location for the anchor tube, take into consideration that there must be
sufficient space to erect and dismount your sunshade.
Danger
2 – 3 mm
distance depending on size of sunshade
