The Unpacking
Before you unfold the boat, take a good look at how the boat is folded together in the
carton. This will assist you in stowing the boat into the carry bag after each use.
Unfold the boat on a flat surface and check the components listed to ensure none are
missing. If any components are missing, do not contact your Maxxon retailer, but
contact us at: (253)373-0166 or email us: [email protected]
Valve Operation & Inflation
Each boat comes with pre-installed Leafield valves. Upon loosening the cover cap you
will find a small center pin beneath. Depress and turn clockwise until the pin rises and
seats into place. Leave the valve in this position during use. Screw in pump to valve,
with clockwise turns to lock pump in place. Proceed to pump up the boat until wrinkles
disappear. To disconnect the pump turn the pump hose counter clockwise. To deflate
the boat, depress the centerpin and turn it counter clockwise to allow the air to
escape.
Losing Air Pressure
The XPW is designed so that does not lose more than 20% of the air in the first 24 hour
period, which is normal for an inflatable craft. Should this occur, do the following.
Check that all valves screwed tightly closed.
Check that all valves are clean and without obstruction.
Examine the entire craft for damage, punctures, etc.
Check all seams for leakage by applying soapy water to discover any small
leaks. Where bubbles surface, there is a leak.
Note:
Understand that lower external air temperatures will cause the boat to deflate to
a certain degree. Conversely, air pressure can also increase with raising temperatures
or also changes in elevation. When traveling with inflatable boats it’s smart to always
leave room for these reasons.
Repairing a Leak
In the unfortunate event of a leak, deflate the boat and then thoroughly clean the
fabric around the leak and allow it to dry. Once dry, use a solvent primer specifically
designated for PVC to give a final cleaning to the punctured area.
With soapy water, locate the point where the air is escaping. Punctures less than 1/16"
in size can be repaired simply without a patch. Apply a small drop of glue to cover the
puncture and let dry for 10 minutes. Then apply another larger drip and then let this
coat dry for over 24 hours. No patch needed.
For holes or puncture between 1/8” and 4”, cut a piece of repair material large enough
to overlap the damaged area by approximately 2 inches and round off the edges.
Using a fine brush, apply glue to the under side of the patch and around the area to be
repaired. Only apply a thin layer of glue, as too much glue will interfere with a proper
