EN
18
Attaching / Detaching the Combi
Nozzle and Crevice Nozzle
• Attaching: Plug the nozzle you want
into the suction opening (
10
) or the
extension tube (
G
). When you do this,
make sure that the locking lug on the
nozzle is pointing towards the release
button. The nozzle must engage
audibly.
• Detaching: Press the release button (
11
)
over the suction opening or on the
extension tube and pull out the nozzle
at the same time.
Removing / Inserting the Dust
Container
• Detaching: Slide the release button (
5
)
towards the dust container (
3
) and pull
it up to detach it.
• Inserting: Insert the dust container
into the motor unit (
E
) from above.
When you do this, make sure that the
locking lug on the dust container fi ts
in the corresponding recess in the
motor unit. The dust container must
engage audibly.
TOUCH DISPLAY
On the touch display (
6
) the following indicators can be read and the suction strength
can be set manually and the
AUTO
programme can be switched on.
Battery status display (
12
)
in per cent, from 10% the battery sym-
bol and the charge control lamp on the
battery fl ash red
Roller error display (
17
)
fl ashes red when the roller is blocked / will
not rotate
Suction blockage
error display (
16
)
fl ashes red when the extension tube or
the nozzle is blocked
Sensor error display (
13
)
fl ashes red when the suction strength
control is no longer working, the vacuum
continues to vacuum in manual mode
IIIIIII
Suction strength (
14
)
3 levels can be set, from Eco to High Speed
AUTO
AUTO programme (
15
)
automatic suction strength setting de-
pending on level of dirt etc., is shown
via the ring (
18
): green = lowest level;
it gradually turns red when the suction
strength is increased; completely red =
highest level
USE
Please Note!
■
Make sure that there are no large,
sharp objects on the surface which is
to be cleaned.
■
Note the
MAX
marking of the dust
container. If the marking is reached
during use, empty the dust container.
Empty and clean the dust container
after every use. The fi lters must also
be regularly cleaned in order to
prevent overloading of the motor.
■
Switch off the device after you fi nish
cleaning each surface to signifi cantly
increase the operating time on each
battery charge. Charge up the battery
