Compact Handheld Dust Mite Vacuum Cleaner
EN
13
NOTICE:
Allow the HEPA fi lter to
dry completely before the device is
reassembled.
6. Insert the HEPA fi lter into the dust
container.
7. Insert the dust container into the motor
unit. It must engage audibly.
Cleaning the UV-C Lamp
Please Note!
■
The UV-C lamp will become hot
during use. Allow the UV-C lamp to
cool suffi ciently after using the device.
There is a danger of burns!
1. Undo the two screws on the cover (
8
)
of the UV-C lamp (
13
) and take off the
cover.
2. Wipe down the UV-C lamp with a dry
duster.
NOTICE:
Make sure that you do not
touch the UV-C lamp with your fi ngers!
3. Place the cover back on and fi x it in
place with the two screws.
Removing the UV-C Lamp
NOTICE
:
Make sure that you do not touch
the UV-C lamp directly with your fi ngers!
Carefully lift the UV-C lamp (
13
) and dis-
connect it from the contacts.
When you fi t a new UV-C lamp, fi rst insert
it into a contact and place it some way
into the recess before inserting it into the
second contact.
Storage
Store the device in a cool, dry place
which is protected from direct sunlight
and is out of the reach of children and
animals.
TROUBLESHOOTING
If the device does not work properly,
check whether you are able to rectify the
problem yourself. If the problem cannot
be solved with the steps below, contact
the customer service department.
Do not attempt to repair an elec-
trical device yourself!
The device generates no suction.
The mains plug is not inserted in the plug
socket correctly.
►
Correct the fit.
The plug socket is defective.
►
Try another plug socket.
There is no mains voltage.
►
Check the fuse of the electrical dis-
tributor (fuse box).
The device is not switched on.
►
Press the On / Off switch (
1
).
Low suction force.
The dust container (
5
) is too full.
►
Empty the dust container.
The HEPA fi lter is dirty.
►
Clean the HEPA filter.
The suction opening (
11
) is blocked.
►
Switch off the device, pull the mains
plug out of the plug socket and
remove the blockage.
The UV-C lamp (13) does not light up.
The automatic switch-off function of the
UV-C lamp has been activated.
►
Check the safety switches (see the
“Safety Devices” chapter).
Unusual odour
The device is being used for the fi rst time.
►
A new odour is normal when the
device is used for the first time; it
disappears after a while.