Vibrating mop.
EN
15
REPLACING THE BATTERY
IN THE HANDLE
The handle (
C
) is equipped with a 12 V
battery, A23 type (already inserted when
the device is supplied) and communi-
cates with the main unit wirelessly. The
battery compartment is located in the
handle. If the device cannot be switched
on even though the battery of the main
unit (
A
) is fully charged, the battery in
the handle may need to be replaced. To
do this, proceed as follows:
1. Remove the three covers using a
sharp object.
2. Remove the two screws in the handle
using a screwdriver.
3. Carefully take the handle apart.
4. Remove the used battery and insert a
new 12 V battery of the A23 type. The
positive pole must be facing upwards.
Before inserting the battery, check
whether the contacts in the handle
and on the battery are clean, and
clean them if necessary.
5. Put both parts of the handle back
together. If necessary, make sure that
the spring rests on the bottom black
button.
6. Reinsert the screws and tighten them
so they are hand-tight.
7. Place the covers back into the holes.
FILLING THE WATER TANK
Please Note!
■
When the water tank is fi lled, the
main unit must
not
be tilted, turned
upside down or laid or placed on its
side. Water could leak out!
1. Flip up the stem mount (
5
) on the
main unit (
A
). It must be upright so
that the device is deactivated and
cannot be switched on accidentally.
2. Open the water tank cap (
11
) on the
main unit.
3. Fill the water tank with water using
the measuring cup (max. 230 ml)
(
Picture D
).
4. Close the water tank cap.
USE
Switch the device off after each
surface has been cleaned as this
will considerably increase the
operating time on each battery
charge.
1. Tilt the stem mount (
5
) on the main
unit (
A
) back a little using the han-
dle (
C
) in order to trigger the release
mechanism and activate the device.
The LEDs (
10
) switches on and the
battery status display (
7
) lights up.
2. Press the On / Off switch (
1
) on the
handle to switch on the device. The
two cleaning feet (
8
) start to vibrate.
3. Guide the device over the surface
which is to be cleaned or polished.
4. If necessary, press the spray trig-
ger (
1
) on the handle to make the
fl oor damp with the aid of the spray
nozzle (
9
).
5. To switch off the device, press the
On / Off switch on the handle again.
The cleaning feet stop vibrating.
6. Tilt the stem mount on the main unit
up a little using the handle in order
to trigger the release mechanism and
activate the device. You must feel the
stem engage. The LEDs switch off
and the battery status display goes
out.
