MAXXMEE 00260, Руководство по эксплуатации

Страница: 13 / 28

Dust mite vacuum cleaner
EN
13
5. Tap out the HEPA-fi lter and clean it
with a soft brush if necessary.
 
For thorough cleaning the fi lter
can be rinsed under
cold (!) run-
ning water.
NOTE: Allow the HEPA-fi lter to dry
completely before the device is reas-
sembled.
6. Insert the HEPA-fi lter into the dust
container.
7. Insert the dust container into the
motor unit. It must audibly click into
place.
Cleaning the UV-C Lamp
1. Undo the two screws on the cover ( 7 )
of the UV-C lamp ( 12 ) and take off the
cover.
2. Wipe down the UV-C lamp with a dry
duster.
NOTE: Make sure that you do not
touch the UV-C lamp with your
fi ngers!
3. Place the cover back on and fi x it in
place with the two screws.
Removing the UV-C lamp
Carefully lift the UV-C lamp ( 12 ) and
disconnect it from the contacts.
When you fi t a new UV-C lamp, fi rst
insert it into a contact and place it some
way into the recess before inserting it
into the second contact.
NOTE: Make sure that you do not touch
the UV-C lamp with your fi ngers!
Storage
• Store the device in a cool, dry place
which is protected from direct
sunlight and is out of the reach of
children and animals.
TROUBLESHOOTING
If the device does not work properly,
check whether you are able to rectify the
problem yourself. If the problem cannot
be solved with the steps below, contact
the customer service department.
Do not attempt to repair an elec-
trical device yourself!
The device generates no suction.
The mains plug is not inserted correctly
in the plug socket.
►
Correct the fit.
The plug socket is defective.
►
Try another plug socket.
There is no mains voltage.
►
Check the fuse of the electrical dis-
tributor (fuse box).
The device is not switched on.
►
Press the On / Off switch ( 1 ).
Low suction force.
The dust container ( 4 ) is too full.
►
Empty the dust container.
The fi lters are dirty.
►
Clean the filters.
The suction opening ( 10 ) is blocked.
►
Switch off the device, pull the mains
plug out of the plug socket and
remove the blockage.
The UV-C lamp (12) does not light
up.
The automatic switch-off function of the
UV-C lamp has been activated.
►
Check the safety switches (see the
“Safety Devices” chapter).
Unusual odour
The device is being used for the fi rst time.
►
A new odour is normal when the
device is used for the first time; it
disappears after a while.