GARNISH RING
GARNISH RING
STEP 7
Complete the installation by placing any excess wiring
to the inside of the roof opening and sliding the Garnish
Ring into position. Fasten in place by using the four
painted flat head screws provided.
NOTE:
DO NOT probe or tamper with the thermostat
sensor or IR sensor shown in illustration #6 above.
7
CONGRATULATIONS!!!
You have successfully completed the
installation of your new
MAXXFAN
.
If you have questions, please visit
AIRXCEL.com or contract your
AIRXCEL / MAXXAIR Distributor.
6A
6B
STEP 6
The interior Garnish Trim Ring must be trimmed to fit
your particular RV roof thickness. To accomplish this,
measure the distance from the vehicle ceiling surface to
each corner of the MAXXFAN Control Plate.
Most RV roofs have some slope, so measuring each
corner is necessary. The Garnish ring should be cut
6mm to 12.5mm longer than the dimensions measured
at each corner.
In Picture #6 below, the installation measures 90mm
from the ceiling (this is an example only) to the Control
Plate. After adding 12mm as in this example, using a
ruler, place a mark at 102mm on each corner of each
side of the Garnish Ring (refer to 6A, right). Once
marked, draw a line connecting all 102 mm marks on the
outside of the Garnish ring and trim accordingly (refer
to 6B, right).
FOR REMOTE CONTROL MODELS:
Refer
to the Operating Instructions for use and testing of
your remote control. Install the two AAA batteries
included, follow instructions, aim remote at the ceiling
unit and test your fan. The Remote Control comes
with a cradle for wall mount storage of the Handheld
Remote Control. Mount the cradle to your wall using
the (2) #6 screws provided. Remote may be placed
into the wall cradle for storage.
THERMOSTAT
SENSOR
90mm
CEILING
6
MEASUREMENTS STATED IN STEP
6 ARE USED AS AN EXAMPLE FOR
ILLUSTRATION PURPOSES ONLY
3
“More information https://www.caravansplus.com.au"
