8
------HI PRESSURE UNITS
1.
2.
3.
4.
Follow directions in the "Getting Started" section.
Once the fan and base are in place and the filter is at the bottom of the cooler, plug in the fan and
unscrew any nozzle on the mist ring by turning it counter-clockwise.
Place the hand pump's hose over the nozzle opening. Use the toggle switch at the fan base to select the
"MIST FAN" option. Ensure the ring valve is in the open position
Squeeze the hand pump bulb up to 10 times until water is visibly drawn through the pump's hose. When
water is consistently flowing through the nozzle opening, turn the ring valve to the closed position,
remove the hand pump hose, and screw the nozzle back in by hand-tightening in the clockwise direction.
5. Once the nozzle is reinstalled, turn the ring valve back to the open position (Fig. C) to resume the flow
of water to the mist ring. Your unit should now be primed and operating.
6.
Turn the switch on the rear fan grille to get the desired speed. This step is optional, as some customers
prefer to run just the pump with no fan.
9
"CDHPl 840GRY wnl m;st focappm,;mately 11 houcs.
**Fan may differ in appearance depending on your model type.
LABELED FAN
Nozzles
Cooler Lid
Cooler Case
1Q
------M1
AINTENANCE
Filter:
D
Nozzles:
Filter should be cleaned before and after each use.
A dirty filter will restrict water flow and could cause permanent damage.
Check nozzles regularly to assure the best performance.
The fog exiting from the nozzles should have an even cone shape. If this is not the case,
the nozzles should be replaced.
Clogged nozzles can be cleaned by removing them from the misting hub and soaking
them in CLR
™
solution or slam them against a hard surface to break the buildup loose.
If they still fail to work, replace them with the provided spare nozzles.
Before reinstalling nozzles, flush water line to misting hub.
