Maxwell MW-2112 BK, Инструкция по эксплуатации

Страница: 13 / 32

13
ENGLISH
tion, unplug the unit, then set the 9 mm
attachment comb (8) or the 12 mm
attachment comb (9) for longer hair
and continue cutting hair near the top
of the head (pic.4).
Step three – cutting temples
Switch the hair clipper off and unplug it,
then set the 3 mm attachment comb (6)
or 6 mm attachment comb (7) and cut
hair in the area of the temples. Then
set the 9 mm attachment comb (8) or
the 12 mm attachment comb (9) and
continue cutting towards the top of
the head.
Step four – cutting the top
of the head
Using the 9 mm attachment comb (8)
or the 12 mm attachment comb (9), cut
the hair on the top of the head towards
the crown against the hair growth direc-
tion.
•
You can cut hair against and along
the direction of hair growth, but
keep in mind that the hair cut
against the growth will be shorter
than the hair cut along the growth.
•
Use the 3 mm attachment comb (6)
and 6 mm attachment comb (7) for
very short haircut. To leave longer
hair, use either the 9 mm attach-
ment comb (8) or the 12 mm attach-
ment comb (9).
•
To leave longer hair, take hair locks
between your fingers and cut the
hair with the clipper (pic. 5).
•
You can use the comb: lift the hair
locks and cut them above the comb
(pic. 6).
•
Always start cutting from the back
of the head.
•
Set the hair with the comb to reveal
uneven locks.
•
Use the scissors to make haircut even
Step five – the final part
–
In the final stage of hair cutting,
remove the attachment comb from
the hair clipper, turn the blades of
the clipper towards the hair and
trim hair on the temples and neck
carefully. Do not press the clipper
strongly, there is danger of injuries
or cuts when open blades come in
contact with the skin (pic. 7).
Cone-shaped haircut
Set the necessary attachment comb
and start cutting from the head back
towards the crown. Cut hair against hair
growth from the head front to the crown
and on the head sides (pic. 8). To get a
flat top haircut, use the comb (11): lift
the locks and cut them along the comb.
Set the hair with the comb (11) to reveal
uneven locks.
Note:
Between operations, you can
hang the clipper on the hanging loop
(5) having preliminarily switched the
unit off using the power switch (1).
CLEANING AND CARE
Lubricating the blades
Regularly lubricate the blades using the
oil (10) supplied with the unit.
–
Switch the unit off using the power
switch (1) and unplug it.
–
Apply one– two drops of oil (10)
on the teeth of the blades (3, 4)
and the back side of the upper
blade (4), switch the unit on and
make sure that the blades are mov-
ing smoothly.
IM_MW-2112_100 x140_2 var.indd 13 19.08.2016 9:19:26