1.
Pack contents check
Join the 2 pieces of boom together using the
joining plate, M5 x 20mm screws M5 nuts and
5mm Shake Proof Washers.
2.
3.
4.
Assembly
A. Rear Boom x 1
B. Front Boom x 1
C. Reflector x 1
G. Joining Plate x 2
H. Shake Proof Washer x 2
I. Nut x 2
J. M5 Screw x 2
K. 6½ Screw x 1
D. Mast Clamp x 1
E. Dipole Cap x 1
F. Dipole x 1
Screw on firmly the Dipole to the Boom.
Slide on and firmly push down the Reflector onto
the groove of the Reflector Bung.
Attach aerial to a suitable mast using the
supplied Mast Clamp. (Note: Mast not supplied).
B
A
D
E
F
G
H
I
J
C
Connecting Coaxial Cable (not supplied)
1.
Thread coaxial cable through Dipole Cap. Strip
away 25mm of outer insulator. Gather outer braid
strands and twist together. Remove 10mm of
inner insulation around inner core.
Loosen the screws on the 2 terminals in the
Dipole. Feed the inner core to one of the
terminals and the twisted braid into the other.
Tighten screws and close Dipole Cap.
Polarisation
Tip: Look at outdoor aerials
in your area to see which
direction to point your
aerial for best reception.
Note model
shown different.
For example only.
Vertical mounting
recommended for
Relay TV transmitters.
Inner
core
25mm
10mm
Outer
braid
Outer
insulator
Inner
insulator
Foil
2.
Horizontal mounting
recommended for
Main TV transmitters.
K
