Maxview Crank Up B2590/65, Инструкция по установке и эксплуатации

Страница: 6 / 20

Attaching Antenna Mount Plate & LNB Park Plate:
1. Remove antenna unit from wooden transit packaging
2. Remove mounting plate from Antenna Unit by removing 6 x M6 nuts using 10mm spanner
3. Clean roof, Mounting Plate and LNB Park Plate in accordance with adhesive manufacturer’s guidelines
4. Mark a centre line for the antenna making sure dish will not overhang vehicle
5. Align notches on plate with centre line
6. Mark the position of 6 screw fixing holes and centre hole
7. Mark position of LNB Park Plate
Page 6
10. Apply rings of adhesive* (see page 4) to
surface of Antenna Mounting Plate and LNB
Park Plate and firmly place them into position.
Important Note:
Adhesive MUST be used to give a water tight
seal between mounting plate and installation
surface.
8. Drill 6 x 2.5mm pilot holes into the roof
9. Using a 32mm holesaw drill the centre hole
through the roof
230mm 65cm (B2590/65)
350mm 85cm (B2590/85)
Direction of travel
Central Line
Antenna Mount Plate
LNB Park
Plate