9
Chapter 2 General Safety Information
（4）Do not install or detach cutting heads or collimators when laser is
active.
（5）It is forbidden to turn on the laser during the mounting of fiber or
cutting head. Carry out commissioning, calibration and focusing at low
output power and then increase the output power gradually when the
calibrating and focusing work is done.
（6） Marking on highly reflective materials is feasible, but you must make
the laser out of focus, or else you may damage the laser.
（7）For collimated outputs, maintaining a clean output lens is essential.
Always close (re-cap) the collimator after use. Do not touch the output
lens and do not clean it with any solvents. Cleaning with the special
solvent and cleaning buds is allowed as described later on in this manual.
WARNING :
◎ Make sure that the individual protective equipment meets the output
power and wavelength range of the laser.
◎ Never look directly into the optical fiber or the collimator, and Use
appropriate laser safety eyewear when operating this device.
◎ Optical damage may result from failure to comply with the above
instructions. Such damage is not covered by the warranty.
WARNING:
◎ Use of controls or adjustments or performance of procedures other than
those set forth in this User’s Guide and related documents may result in
hazardous radiation exposure.
4 .Electrical Operating Instructions
Q-Switched pulsed fiber laser (MFP100W-300W) Series supply
voltage:
220/110VAC
。
