MULTIMAX USER GUIDE 93
INTERFACE MODE:
MA-2040(config)# interface Ethernet 0
MA-2040(config-e0)# ?
//check what commands can be used in
interface mode
exit
Exit from current mode
end
Exit to normal mode
ip
Set the IP address of an interface
mtu
Set the IP address of an interface
5.2 How to configure the CLI
Following is a list about the description of help and the error should be encountered in the
configuring program.
Commands /tips
Description
?
Typing a question mark “?” everywhere needed that will show
us the helpful information.
Ctrl+c
Press these two keys at the same time , except its “copy”
function but also can be used for “break” out of the setting
program .
Invalid command “xxx”
Parameters “xxx” are not supported by the system , in this case,
enter a mark “?” instead of “xxx” will help to find out the
correct parameters about this issue.
Incomplete command
Parameters haven’t been finished yet .
% Invalid input detected at '^'
marker
'^' marker indicates the location where is set wrong .
NOTE: Almost all the parameters to be set are in the
Global configuration mode
, commands
set
,
add
are very important for this mode. If some parameters can’t be found in the Global
configuration mode, please move back to
Privileged exec mode
or move up to
Interface mode
.
NOTICE: Knowing the
CLI hierarchy level modes
is necessary before configuring the CLI. If
you don’t, please go back and read it quickly in chapter 5 !
Содержание MULTIMAX MA 2040
Страница 1: ...Dual Port Dual SIM Industrial Cellular Router User Guide V1 01...
Страница 44: ...MULTIMAX USER GUIDE 43...
Страница 88: ...MULTIMAX USER GUIDE 87 The modification will take effect after Apply Save Reboot...
Страница 90: ...MULTIMAX USER GUIDE 89 The modifications will take effect after click Apply Save Reboot...
