Maxon GMRS-21X, Руководство пользователя, Страница: 9 / 19

Installing and Removing a Battery Pack, Continued
To install the Alkaline or Ni-Cad battery pack, hold the
radio face down in one hand; the battery pack (flat side
up) in the other. Orient the battery so that the 2 metal
battery contacts are toward the bottom of the pack. Locate
the tab at battery top and the slot at radio top panel. Turn
the battery pack over in your hand, and tilt the tab end
slightly downward to insert it into the slot. Lower opposite
end of battery toward radio and press firmly until a click
is heard and battery pack is firmly seated.
To remove either pack from the radio, hold the radio face
down in one hand and use the thumb of other hand to
press and hold the battery latch (at the battery pack base).
Use gentle upward pressure to raise the battery about 1/2"
from the radio back. Lift and pull the battery pack away
from the radio, being careful not to break or put pressure
on the battery pack tab.
Attaching and Removing the Belt Clip
The belt clip attaches to the upper right corner of the radio
back. To attach, position the belt clip so that the deep
slotted area faces the holder on radio back. Insert the
holder into the slot, and slide the belt clip upward. A click
will be heard, confirming the belt clip is firmly seated on
the holder. Open belt clip (by pressing top of clip) and
attach to belt, pocket or other convenient location.
To remove the belt clip, simply push and hold the release
button (located at the top of the belt clip) while sliding the
belt clip down off the holder on radio back.
8