4
SP-0402
Features
·
Wideband frequency separation
·
1 or 5 W programmable output power
·
Programmable 12.5/25 kHz channel spacing
·
Channel
scan
·
Priority channel scan
·
Look back channel
·
CTCSS/DCS/ tone signaling
·
Busy channel lockout
·
Time-out
timer
·
Priority
Channel
Edit
Description of Radio Components
1) Antenna Receptacle
2) Channel Selector Switch
3) On/Off - Volume Control
4) RX/TX Indicator
5) Battery Latch
6) Push-To-Talk (PTT)
7) Monitor Button
8) Option Button
9) Emergency Button
10) Microphone
11) Accessory Connector (EXT Jack)
12) Belt Clip
13) Battery
14) Battery Charge Contacts
15) Speaker
Antenna Installation
Fasten the antenna to the radio by turning the antenna clockwise into the receptacle on top of the
radio.
Installing and Removing the Battery Pack
To Install:
Position the guides of the battery in line with the radio battery guide rails and slide the battery into
position until a click is heard.
To Remove:
Holding radio in one hand, push and hold battery latch button located in the upper right hand
corner of the battery pack , held as if looking at the back of the unit. Hold radio firmly and slide
battery in downward direction while pushing the battery latch button.
Attaching and Removing the Belt Clip
To Install:
