2.2 The Back Panel
Figure 2-2
Wireless
antenna
Factory
Default
R
eset button
There
are
t
h ree ways to reset the AP's factory defaults:
• Use
the
Factory Defaults
function on
System Tools
->
Factory Defaults
page in the
AP's Web-based Utility.
•
Use the Factory Default R
eset button: Pr ess and hold the default Reset button for 5
seconds, and then the AP reboot after the System led flash 5 times.
•
Use the Factory
Reset button: First,
Default
turn off the AP's power. Second, press and
hold the default Reset button then turn on the AP's power, until the system LED lights up
(about 3 seconds). Last, release the reset button and wait for the AP to reboot.
Note:
Ensure the AP is powered on before it restarts completely.
One LAN 10/1
0
0Mbps RJ45 port for connecting the AP to hub or switch
AC
power
socket:
Only
u se the power adapter provided with the WA7500-SG 108Mbps
Wireless Access Point; Usage of a different adapter may result in product damage.
2.3 System
Requirements
Broadba n d Internet Access Service (DSL/Cable/Ethernet)
One
DSL/Cable
M
odem that has an RJ45 connector
A Ethernet broadband r o
uter
TCP/IP
protocol
m
ust be installed on each PC
Web
brow
ser, such as Microsoft Internet Explorer 5.0 or later, Netscape Navigator 6.0 or later
802.11g or 802.11b-compliant devices, su ch as the WA7500-SG Wireless Adapter
2.4 Installation Environment Requirements
Not
in direct sunlight or near a heater or heating vent
4
108M Wireless Access Point User Guide
MAXNET WA7500-SG
