• To reduce the risk of death, personal injury or property damage from
fire, electric shock, falling parts, cuts/abrasions, and other hazards
read all warnings and instructions included with and on the fixture
box and all fixture labels.
• Before installing, servicing, or performing routine maintenance upon
this equipment, follow these general precautions.
• Commercial installation, service and maintenance of luminaires
should be performed by a qualified licensed electrician.
• DO NOT INSTALL DAMAGED PRODUCT!
• This fixture is intended to be connected to a properly installed and
grounded UL listed junction box.
WARNING:
RISK OF ELECTRICAL SHOCK
• Turn off electrical power at fuse or circuit breaker box before
wiring fixture to the power supply.
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the
luminaire label information.
• Make all electrical and grounded connections in accordance
with the National Electrical Code
and any applicable local code requirements.
• All wiring connections should be capped with UL approved wire
connectors.
CAUTION:
RISK OF INJURY
• Wear gloves and safety glasses at all times when removing luminaire from carton, installing, servicing
or performing maintenance.
• Avoid direct eye exposure to the light source while it is on.
• Account for small parts and destroy packing material, as these may be hazardous to children.
CAUTION:
RISK OF FIRE
• Keep combustable and other materials that can burn away from luminaire and lamp/lens
• Do not mount to flammable or combustible surfaces.
• MIN 75°C SUPPLY CONDUCTORS.
Input Rating:
120V-277V 50/60Hz
Operating Temperature:
-40°F to 104°F
Models:
CPL Series
Operating Instructions
CPL Series
MaxLite LED Low-Profile Garage & Canopy Luminaire
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: [email protected]
Page: 1
REV: 12/13/21
®
Picture is for illustration purposes
only. Your model may vary.
General Safety Information
For sensor information visit:
https://www.maxlite.com/Controls/MSHYTHC403V9RC.pdf
Or scan the QR code:
