Maxkon STAR 2000, Инструкция по установке и эксплуатации

Страница: 6 / 8

IMPORTANT: Correct install position
CAUTION:

Ensure mains power is OFF before commencing installation.

The supplied mains cable must not contact the top surface of the heater during operation.

Heater must not be located immediately below a socket outlet. Electrical connections must be made outside
of the footprint of the unit to avoid heat build-up. If the heater is to be mounted on an incline (e.g.
sloping roof), ensure the electrical connection is located below the lowest end of the heater.

Joists, beams and rafters shall not be cut or notched to install the appliance.

This heater is not intended for ceiling-recessed installation. Do not install pointing directly downwards.

The identification mark and model reference should be visible after installation.

The STAR must not be attached facing or close to any combustible material (eg, wood or PVC cladding, fascia
or soffit) or other materials that could blow onto the heater.

The fixed wiring insulation coming into contact with parts with a temperature rise of greater than 50°C must
be protected, for example, by sleeving having an appropriate temperature rating.

Exercise caution when siting the heater stand that the heater cannot accidentally be touched, knocked-over
or that the wire causes a tripping hazard.

Never place the stand and heater next to a swimming pool, pond or other water source.
INITIAL USE:
The unit may emit odour or vapour on initial use or if heater has not been used for an extended period.
This is norma