MAXISJAX OWNER’S MANUAL
MAXISJAX OWNER’S MANUAL
9
10
SETUP AND OPERATION
1. Always wear gloves, eye protection and hard hat when
working with MaxisJax.
2. Use only a 1 1⁄2” or 2” rigid conduit as an axle.
3. Place conduit axle through wire reel. (Fig. 1)
4. Lift the Back Brace (9) by pulling up on the Maxis Lever
(8), rotate Front Arm (3) forward. Place Leveler Pin (11) in
desired set hole on Base Leg (1).
5. Raise Max Lever (8) so that it is pointing straight upward.
6. Open Upper Jaw (6).
7. Adjust height to clamp Jaws onto axle. Lift and place Leveler
Pin (11) into appropriate hole on the Base Leg and or adjust
Telescoping Arm (2).
8. Close Upper Jax (6) on axle by replacing Hitch
Pin (5).(Fig. 2)
9. For minor leveling and height adjustments use a wrench
on the Leveler Pin (11) to increase or decrease leg
height. (Fig. 3)
10. To lift reels push down on Max Lever (8) until lever is
parallel with Back Brace. (fig 4)
(Fig. 1)
(Fig. 2)
(Fig. 3)
