OPERATION (CONT.)
CRONUS
30 Barnet Boulevard
New Bedford, MA 02745
(508) 9952200
Page 7
OPTIONS AND OTHER SETTINGS
Cronus contains a number of settings that are changed infrequently.
These settings are Year, AM/PM or 24Hour and, Automatic Daylight
Saving enable. These can only be set by starting the set everything
mode. To start the set everything mode, simply press and release
the switch mounted on the back of the instrument. Cronus will start
the set everything mode which consists of the following items in the
order they are presented.
1. Year setting:
Cronus can be set for any year from 2015 through
2099. The setting procedure is like the procedure used for setting
time, date or, tide time as described on page 5.
2. Date setting:
see page 5.
3. Automatic Daylight Saving Time enable:
The display shows “UdS” for Use
daylight Saving, followed by a flashing “0” or, “1”. “0” indicates that the feature is
turned off, “1” indicates the feature is turned on. Use the “Set” switch to change
the setting. When finished, press “Select” followed by “Set”, like the other setting
functions, to go to the next function. Note: the daylight saving changes follow the
North American standard. Time is advanced one hour at 2:00AM on the second
Sunday of March and, set back one hour at 2:00AM on the first Sunday of November.
4. AM/PM or 24Hour display mode:
Use the “SET” switch to alternate
between the two modes. The small function lights will blink and the main
display will show “24” or, “AP” to indicate which mode is
selected. To finish press “SELECT” and then “SET” as with
the other settings
5. Time setting:
see above.
6. Tide setting:
see above.
7. Brightness setting:
You can adjust the brightness of the
LED display in 16 steps to better match other instruments you own. When this
setting mode is entered the current brightness value is shown preceded by a “b”.
Press the “SET ALL” switch mounted on the back of the instrument to increase
the brightness level. If the current brightness is at “b16” (maximum) when you
press the “SET ALL” switch it will change to “b01” (minimum). The actual display brightness also changes
at the same time as the value. When you are finished adjusting the brightness press the toggle switch to
“SELECT”.
1.800.561.8187
Fluke-Direct
.ca
