Maximum 058-9372-4, Инструкция по эксплуатации

Страница: 10 / 13

19 18
model no. 058-9372-4 | contact us 1-888-670-6682
NOTE:
For further repair information, please
call 1-888-670-6682.
PROBLEM POSSIBLE CAUSES SOLUTIONS
Tool runs at
low speed.
Air flows
slightly from
exhaust. Motor parts are
jammed with dirt.
Power regulator is in
closed position.
Air flow is blocked
by dirt. Check whether there is blockage
in air inlet and filter.
Pour pneumatic tool oil into air
inlet plug as per instructions.
Operate the tool, changing
direction of rotation back and
forth in short bursts. Repeat the
above steps as needed.
Tool stops
working.
Air flows
freely from
exhaust. One or more motor
vanes are stuck
due to material build up. Pour pneumatic tool oil into the air
inlet plug.
Tap motor housing gently with
plastic mallet.
Operate the tool, changing the
direction of rotation back and forth
in short bursts (wherever applicable).
Disconnect the tool from the air
supply. Operate motor manually by
rotating the drive shaft (wherever
applicable).
Tool does
not shut off. Throttle valve O-rings
are dislodged from
inlet valve.
If the problem persists,
call 1-888-670-6682.
WARNING!
Potential hazard that could result in serious injury or
loss of life.
• If any of the following symptoms appear while the tool
is in use, turn it off and disconnect it from the air
supply immediately. Failure to heed this warning will
result in serious personal injury.
• Disconnect the tool and the electrical plug from the air
supply before making any adjustments.
• Repairs must be performed by a qualified service
technician only.
Replace O-rings.
Troubleshooting
The following chart lists common issues and solutions. Please read it
carefully and follow all instructions closely.
Tool runs at
normal speed
but loses
power under
load. Motor parts are worn
or damaged.
Cam clutch is worn or
stuck due to lack of
lubricant.
PROBLEM POSSIBLE CAUSES SOLUTIONS
1. Lubricate clutch housing.
2. Check for excess clutch oil,
overfilling can cause drag on
high speed clutch parts. A typical
oiled/lubricated wrench requires
1/2 ounce (1.5 ml) of oil.
Grease lubrication:
Heat is generated due to
insufficient grease in the chamber.
Severe operating conditions may
require frequent lubrication.
If the problem persists,
call 1-888-670-6682
1.
2.
1.
2.
3.
1.
2.
3.
1.
2.
3.
4.
TM