Maximum 058-9365-2, Инструкция по эксплуатации

Страница: 9 / 13

17 16
model no. 058-9365-2 | contact us 1-888-670-6682
WARNING!
Potential hazard that could result in serious injury or
loss of life.
• Disconnect the tool from the air supply before changing
accessories, servicing, or performing maintenance.
• Only use the tool after replacing or repairing any
damaged parts or accessories.
• Use only recommended and properly rated replacement
parts. Failure to comply could result in serious injury or
loss of life.
DANGER!
Potential hazard that will result in serious injury or
loss of life.
• Keep children away from the work area.
Do not allow children to handle power tools.
Storage
If it is necessary to store the tool for an extended period of time, apply a
generous amount of lubrication before storing. The tool should be allowed
to run for approximately 30 seconds after lubricating, in order to ensure
that the lubrication is uniformly distributed throughout the tool.
• Lubrication: If the Air-powered Hammer/
Chisel and the compressor are not equipped
with an in line lubrication system, place up to
six drops of pneumatic tool oil into the air
inlet before each work day or after every
two hours of continuous use, depending
on the characteristics of the workpiece.
• Do not use a worn or damaged chisel or quick-change retention spring.
• Disconnect the tool from the air supply when it is not in use .
• Check the air supply for correct size and type of hose connec tors. Ensure
that there is no additional drain on the air line and no moisture or
restriction in the air pipe to avoid loss of power or erratic action.
General inspection
free movement
Trigger, spring,
safety mechanism
None
X
Worn or broken
parts
X X
Replace worn or
broken parts
X
Lubrication See below
Pneumatic
X
MAINTENANCE
REQUIRED
DESCRIPTION
TOOLS OR
MATERIALS
REQUIRED
MAXIMUM SERVICE INTERVAL
Each use or
every 2 hrs
Monthly
As
needed
In-depth inspection
CAUTION!
Potential hazard that may result in moderate injury or
damage to equipment.
• The tool should be stored in a clean and dry
environment. Failure to comply may result in
moderate injury or damage to equipment.
tool oil
TM