15
TM
OPER
A
TING INS
TRUCTIO
NS
Open-Ended
Closed-Ended
Fig. A
Fig. B
Fig. C
Fig. E
MOUNTING / CHANGING THE SANDING SHEET
•
Completely remove the flange.
•
Install the sanding pad over the accessory interface.
•
Reinstall the flange.
•
Align the holes of the perforated sanding sheet with the
slots of the perforated sanding pad and press the sheet
onto the pad. (Fig. E)
•
Firmly press the oscillating tool with the installed sanding
sheet against a flat surface and briefly switch the power
tool on. This provides for good adhesion and prevents
premature wear.
•
If one point has become worn after use, pull off the
sanding sheet, turn it 120°, and re-install.
OPERATING THE ON/OFF SWITCH
•
Switching the power tool on: slide switch forward.
•
Switching the power tool off: slide switch backward.
USING THE VARIABLE SPEED DIAL
Select oscillation frequency (speed) while the motor is
running.
The variable speed dial can be used to set the optimum
oscillating frequency according to the accessories used and
the respective application.
High oscillation frequency
Sanding, sawing, rasping and polishing stone and metal.
Low oscillation frequency
Scraping, polishing varnishes.
LED LIGHT
The sight light allows you to keep a clear view under less
illuminated circumstances. To turn on the light, simply press
the on/off switch. When you release the on/off switch, the
light will turn off.
CONSTANT SPEED
Your tool is equipped with an internal constant speed control
system which helps keep the preselected speed virtually
constant between no-load and load conditions.
