Maximum 054-7160-8, Инструкция по эксплуатации

Страница: 5 / 14

model no. 054-7160-8 | contact us 1-888-670-6682
8 9
• To reduce the potential risk of damage to the electric plug and cord,
pull by
the plug rather than the cord when disconnecting the charger from the power
supply.
• Make sure the cord is located so it will not be stepped on, tripped over, or
otherwise subjected to damage or stress.
• An extension cord should not be used unless absolutely necessary.
Use of an
improper extension cord could result in a risk of fire, electric shock or electrocution.
• Do not operate the charger if it has received a sharp blow, been dropped or
otherwise damaged in any way.
• Do not disassemble charger.
Take it to a Service Agent when service or repair is
required. Incorrect reassembly may result in a risk of electric shock, electrocution
or fire.
• To prevent the risk of electric shock, unplug the charger from the outlet before
attempting to clean it. Only removing the battery pack from the charger will not
reduce this risk.
• DO NOT store or use the tool and battery pack in locations where the
temperature may reach or exceed 122 °F (50 °C),
which can lead to deterioration
of the storage battery.
• The charger is designed to operate on standard household electrical power
(120 V AC).
Do not attempt to use it on any other voltage.
SPECIFIC SAFETY RULES FOR CORDLESS DRILL/DRIVER
• Use the auxiliary handle(s).
Loss of control can cause personal injury.
• Hold the power tool by insulated gripping surfaces, when performing an
operation where the cutting accessory or fasteners may contact hidden wiring.
Cutting accessory or fasteners contacting a “live” wire may make exposed metal
parts of the power tool “live” and could give the operator an electric shock.
SAFETY INSTRUCTIONS WHEN USING LONG DRILL BITS
• Never operate at higher speed than the maximum speed rating of the drill
bit.
At higher speeds, the bit is likely to bend if allowed to rotate freely without
contacting the workpiece, resulting in personal injury.
• Always start drilling at low speed and with the bit tip in contact with the
workpiece.
At higher speeds, the bit is likely to bend if allowed to rotate freely
without contacting the workpiece, resulting in personal injury.
• Apply pressure only in direct line with the bit and do not apply excessive
pressure.
Bits can bend causing breakage or loss of control, resulting in personal
injury.
SAFETY RULES FOR BATTERY PACK AND CHARGER
• If the battery pack casing is cracked or damaged, do not insert into charger.
There is a danger of electric shock or electrocution.
• Don
,
t allow any liquid to get inside charger. Electric shock may result. To
facilitate cooling of the battery pack after use, avoid placing the charger or
battery pack in a warm environment such as in a metal shed, or a trailer that is not
insulated.
• This charger is not intended for any uses other than charging rechargeable
batteries.
Any other use may result in risk of fire, electric shock or electrocution.
• Do not place any object on top of the charger or place the charger on a soft
surface that may result in excessive internal heat.
Do not place the charger near
any heat source.
S
AFETY INS
TRUCTIONS
S
AFETY INS
TRUCTIONS