Maxim Integrated
│
2
www.maximintegrated.com
Evaluates: USB2GPIO
USB2GPIO# Adapter Board
Quick Start
Required Equipment
●
PC with Windows OS (Windows 7, Windows 8, or
Windows 10) with a USB port
●
USB2GPIO# board
●
A-to-Micro-B USB cable (not supplied)
●
Munich software V2.17 or later
●
Supported I
2
C or SPI interface device for communication
like MAX14001PMB# board
Procedure
The USB2GPIO# is fully assembled and tested. Follow
the steps below to verify board operation:
1) Go to
www.maximintegrated.com/evkitsoftware
to download the most recent version of the Munich
GUI software,
MUNICH GUI
. Save the software to a
temporary folder and decompress the
Munich_GUI-
SetupV2.17.zip
file.
2) Connect the USB cable between the USB2GPIO#
board and the PC; the USB driver is installed
automatically.
3) Ensure that the companion SPI interface device’s
jumper settings are correct. Refer to your companion
device’s documentation.
4) Connect the USB2GPIO# board’s 2 x 6-pin, right-
angle connector to the companion device’s 2 x 6-pin,
right-angle header, as shown in
Figure 2
.
5) Once the USB2GPIO# board is connected to the
companion device, open the
MUNICH GUI.exe
(double-click) software.
6) Start the Munich GUI software and select the tab
sheet that corresponds to the companion device.
Follow instructions in the companion device data
sheet to test it in conjunction with USB2GPIO#.
Figure 2. USB2GPIO# Board Connected with MAX14914PMB#
