MaxFlight FS-3000, Руководство пользователя

Страница: 54 / 131

54
18. Remove the entry module and connect all Comm. modules on top of the inverters.
Snapped into place. Tighten set screw.
19. Turn power “OFF” to power box for two minutes.
2-4 Input 3-phase Wiring
The wiring of the individual phases of input power to the controllers does not make any
difference in the behavior of the drive motors. Guarantee that220/380/415/440/480 three phase
50/60 Hz, 20 amp power is available. Measure the AC voltage values with a good multi-meter,
voltage values must be or – 10% before connecting same to power box. Or for U.S. 208
VAC 20 amp.
2-5 Output 3-phase Wiring
WARNING! Before removing/relocating any wires make sure power has been OFF for at least
10 minutes so the internal storage capacitors can discharge.
The wiring of phases between the inverter controller and the motor affects the direction of
motor movement. Reverse any two (2) phases of the controllers output to the motor, to reverse
motor direction. Before removing/relocating any wires make sure power has been OFF for at
least 10 minutes. The internal storage capacitors must discharge
You must test and set correct drive rotation of all motors. This will be tested later in the
rotation test sequence.
Output power to the motors from inverters is digital DC in an AC sine wave shape. You
cannot test this value with a standard voltmeter.
2-6 Auto Tuning the Inverters
After the inverters have been initialized you must load or verify that the new
Motion_G3EH_LENZE_1.0.8 and Motion_G3EH_Lenze_PCI_1.0.1 has been installed on
motion computer. All control cables/wiring
has been properly installed on the machine.
Auto tuning of the inverters is required before you can run anything using the motors
and inverters. The inverters have to check themselves and verify that they are connected
to a motor and there are no faults in the wiring. To perform the auto tuning sequence
follow the below instructions:
1. R-click on red “M” on desktop, select OPEN and allow program to open fully.
2. Pull out E-stop front of cabinetry.
3. The RED inverter lights must turn to GREEN and flash.
a. This indicates that the inverters are communicating with the motion
computer.
b. If they do not flash green then you must troubleshoot the comm. wiring or
verify power is ON to inverters.
c. The lights must flash green on both inverters or rest will fail