Installing the Air Duct
Removing the Air Duct
Installing the Front Bezel
Removing the Front Bezel
Removing the Server System Cover
Remove the shipping screws (A).
While pressing the blue buttons at the top of the chassis (B), slide the top cover back
until it stops (C).
Unlock the bezel if it is locked.
Lock the right end of the front bezel to the rack handle (A).
Remove the left end of front bezel from the rack handle (A).
Carefully push down the air duct into place, making sure that the cables run through
the provided openings.
Rotate the front bezel clockwise till the left end clicks into place (B).
Remove the air duct by lifting it straight up.
Align the two holes on the air duct with the alignment pins on the chassis.
Rotate the front bezel anticlockwise to release the latches on the right end from the rack
handle (B).
Lock the bezel if needed.
MAXDATA PLATINUM 1600 IR M3 – Quick Start Guide
3
Grasp the riser assembly with both hands and pull it up to remove it from the system.
Position the riser card edge connector over the server board riser socket and align the
two hooks on the back edge of the riser assembly with the slots on the back of the
chassis, then press it straight down into the riser socket.
Removing the PCI Card Riser Assembly
Installing the PCI Card Riser Assembly
Riser card connector
Hooks
Slots
