www.maxcessintl.com
Global Brake Series
MI 850A169 1 L
Page 12 of 14
14.
Press the other bearing onto the end of the rotor shaft until it seats against the internal snap ring of the right
stator.
NOTE:
The seal side of the bearing must face the inside of the brake.
15.
Tighten the stator screws evenly until the left and right stators are clamped together.
16.
Apply 2 or 3 drops of wicking Loctite to the inner and outer race of both bearings. Wait ten seconds and
wipe off the excess Loctite.
17.
Install the other external snap ring on the rotor shaft against the bearing. This step is made easier by
supporting the brake on the opposite end of the rotor shaft.
NOTE:
Insure that the right bearing is seated against the internal snap ring before attempting to install the
external snap ring.
18.
Manually rotate the rotor shaft to insure smooth operation of the rotating parts.
19.
Place the brake on a clean piece of paper. Support the brake at 45° so that the cross-drilled holes are
facing up. Fill the brake with all of the magnetic powder supplied in the repair kit. While filling, slowly rotate
the rotor to evenly distribute the magnetic powder.
NOTE:
Collect any spilled magnetic powder from the clean paper and pour it into the brake.
20.
Install the powder fill screw (and washer for GBA, GBAM, GBB & GBBM only) into the right stator. All other
models have a blind rivet.
21.
Install the collar and set screws onto the rotor shaft.
