Maxatec MT-41, Руководство пользователя

Страница: 7 / 14

10
11
2-4. Di p Switch Setting
The printer is set up at the factory to be appropriate for almost all users. On the other hand,
offers some more settings for users with special requirements.
It has DIP switches that allow you to change communication setting, such as handshaking and parity
check, as well as print density.
The functions of the dip switche is shown in the following tables.
♣
Note : Power off. And open the cover of Dip Switch and change setting.
2-4-1. Serial Interface Specification
DIP Switch Functions 1
SW FUNCTION ON OFF DEFAULT
2 Hexadecimal HEXDUMP NORMAL OFF
3 Hand Shaking XON/XOFF DTR/DSR OFF
DIP Switch Functions 2
(
Baudrate selection)
Transmission speed SW-7 SW-8
11520 bps ON ON
9600 bps OFF ON
19200 bps ON OFF
38400 bps OFF OFF
DIP Switch Functions 3
Print Density
Print Density SW-5 SW-6
Low Power ON ON
Normal OFF ON
Normal ON OFF
Dark OFF OFF
Emulation
FUNCTION SW-4
ESC Pos OFF
♣
CAUTION:
Turn off the printer while removing the DIP switch cover to prevent an electric short, which can
damage the printer.
1. Make sure the printer is turned off.
2. Remove the screw from the DIP switch cover. Then, take off the DIP switch cover as shown in
the illustration below.
3. Set the switches using a pointed tool, such as tweezers or a small screwdriver.
4. Replace the DIP switch cover.
The new settings take effect when you turn on the printer.
DETAIL A
SCALE 2:1