9
NAIL LOADING
1
Pull pusher back into "locked" position
2
Insert the finish nails into the magazine
3
Push the pusher lock button and put back the pusher.
TEST OPERATION
1
Adjust the air pressure at 70 p.s.i. (5 bar) and connect the
air supply.
2
Without touching the trigger, depress the contact arm
against the work-piece.
Pull the trigger (The tool must fire the fastener.)
3
With the tool off the work-piece, pull the trigger.
Then depress the connect arm against the work-piece. (The
tool must fire the fastener.)
4
Adjust the air pressure as much as the lowest possible accord-
ing the length of fastener and the hardness of work piece.
AIR HOSE CONNECTION
Connect the air chuck to the air plug.
When connecting the air chuck, do not point the nail dis-
charge outlet at any part of your body or at another person,
and do not touch the trigger.
DRIVING FASTENERS
NOTE :
This tool is shipped with SEQUENTIAL TRIP selected.
SEQUENTIAL TRIP
The Sequential Trip requires the operator hold the tool against
the work before pulling the trigger.
This makes accurate fastener placement easier, for instance on
framing, toe nailing and crating applications.
The Sequential Trip allows exact fastener location without the pos-
sibility of driving a second fastener on recoil, as described under
"Contact Trip".
The Sequential Trip Tool has a positive safely advantage be-
cause it will not accidentally drive a fastener if the tool is contact-
ed against the work or anything else-while the operator is holding
the trigger pulled.
Switching SEQUENTIAL TRIP to CONTACT TRIP
ALWAYS-disconnect air supply before switching the trigger-
ing method.
1
Press the button on the trigger.
Finish nails
Pusher
WARNING
WARNING
Button
